ESP Logo
 Elliott Sound Products Project 62-D 

LX-800 System Connections

Share |

WARNING: It is ESSENTIAL that all fusing specifications are followed precisely. Because of its capabilities, the LX 800 CAN overload the local mains supply found in small clubs and theatres. Rather have the fuse blow than the whole darned place go into instantaneous blackout!

These are the basic connection diagrams of the LX-800. Start with a minimum system configuration and build it up as budget allows. Remember that the precedence protocol will work on those sections that do not have their own DIM-RAK 8s. Just link the in-out 15-pin connectors on the rear panel, as shown below.

Basic This shows a minimal system

In fact, the audio feed and strobe head don't even have to be there. A console and a DIM-RAK 8 are all that are required for a simple lighting system.

Because of the precedence system used, every function on the console will work with only a single DIM-RAK 8. The outputs from the various functions are bridged with the cables shown, so that everything is connected.
 
Advanced The maximum system configuration looks like this.

Each section connects to its own DIM-RAK 8. Obviously, the maximum power rating of the incoming supply must NOT be exceeded, but this diagram shows just how versatile the LX-800 can be.

Any variation between the minimum and maximum can be used, so 2 or 3 DIM-RAK 8 units can be connected to the panel, and the additional console functions bridged to the master bus as shown above. This gives very good flexibility to get the most functions from the least equipment.

There is no real reason that the DIM-RAK 8 units cannot be spread across the 3 phases usually available - this distributes the load and allows greater overall power from the system.

The connector designations are as follows ...

Fader Banks (A and B)P1
ChaserP2
Sound to Light (S2L)P3
Switched OutputsP4
Master BusS1, S2, S3
Connector Designations

All cables are wired conventionally. There is a male (plug) on one end, and a female (socket) at the other. DB15 connectors are used throughout, with pin1 (plug) wired to pin 1 (socket) in all cases. Cables are interchangeable - all connections are wired in all cables.

While it may be tempting to take short cuts to save wiring, this will only come back to bite you when the system is in use. By making all cables the same, this ensures that any cable can be used in any location without problems.

Each cable will connect (and join) the +10V, +12V, -12V and 0V (earth/ground) from each dimmer unit. While this does not automatically mean that the power supplies will current-share perfectly, the paralleled connections do mean that there will always be plenty of 'juice' available, even if one supply is unable to cope - the others will fill the shortfall.

Overview Channels & S2L Strobe & Chaser Power Control Connections Miscellaneous


 

IndexProjects Index
ESP HomeMain Index

Copyright Notice. This article, including but not limited to all text and diagrams, is the intellectual property of Brian Connell and Rod Elliott, and is  Copyright (c) 2000. Reproduction or re-publication by any means whatsoever, whether electronic, mechanical or electro-mechanical, is strictly prohibited under International Copyright laws. The author/editor (Brian Connell/Rod Elliott) grants the reader the right to use this  information for personal use only, and further allows that one (1) copy may be made for reference while constructing the project.  Commercial use is prohibited without express written authorisation from Brian Connell and Rod Elliott.
Page Created and Copyright (c) Rod Elliott/Brian Connell 14 Jul 2000